Fuel Mixture - FUTABA T18MZ Instruction Manual

'HGLFDWHG PL[LQJ XVHG LQ QHHGOH DGMXVWPHQW RI HQJLQHV ZKLFK XVH D IXHO PL[WXUH
)XHO 0L[WXUH
FRQWURO FDUEXUHWRU >$LUSODQH KHOLFRSWHU@
This function is dedicated mixing used in needle
adjustment of an engine that uses a fuel mixture
control carburetor.
7RXFK WKH >)XHO 0L[WXUH@ EXWWRQ LQ WKH 0RGHO 0HQX WR
call the setup screen shown below.
6HWWLQJ PHWKRG
&750 PRGH Maximum change near center by
center trim operation (Does not change at end of
the stick movement) When the adjustment range
(Range) value is made small, trim is active only
near the center.
1250 PRGH Normal trim (linear) operation.
When the adjustment range value is decreased,
trim is active only near the center. Needle high
trim works as high trim based on the center. This
operation is similar to reverse ATL trim.
 $Q DFFHOHUDWLRQ IXQFWLRQ FDQ EH VHW 7KLV
is used when the mixture is either too rich or
too lean, which can be caused by sudden
RSHUDWLRQ RI WKH WKURWWOH VWLFN
 7KH UHWXUQ WLPH DIWHU RSHUDWLRQ 'XPS FDQ
*The needle channel is assigned to CH9 as a default.
5HWXUQ WR 0RGHO 0HQX
2SHUDWLRQ FXUYH VHWWLQJ
(For a description of the setting method, see the description at the
back of this manual.)
EH VHW IRU ERWK VHWWLQJV $FFHOHUDWLRQ+LJK 
 $ QHHGOH WKURWWOH FXW IXQFWLRQ FDQ EH VHW
 7KLV RSHUDWLRQ FDQ EH OLQNHG ZLWK WKH WKURWWOH
KROG IXQFWLRQV &XW DQG ,GOH  7KURWWOH &XW
IXQFWLRQ DQG ,GOH 'RZQ
 7KH QHHGOH VLGH FXW SRVLWLRQ FDQ EH VHW 6HW LW
to the fuel side full open position.
:KHQ MIX mode is selected, the throttle
curve setting becomes the master.
,Q WKH UNMIX PRGH WKH WKURWWOH VWLFN SRVLWLRQ
becomes the master.
<Model Menu (Common Functions)> 109