Ricoh SP C400DN User Manual page 4

R CAUTION:
• When removing misfed paper, do not touch the fusing unit because it could
be very hot.
• When moving the machine, hold the inset grips at both sides, and then lift
the printer slowly. Lifting it carelessly or dropping it may cause an injury.
• Before installing options, the machine should be turned off and unplugged
for at least half an hour. Components inside the machine become very hot,
and can cause a burn if touched.
• Do not touch the inside of the controller board compartment. It may cause
a machine malfunction or a burn.
• Before moving the machine, unplug the power cord from the wall outlet. If
the cord is unplugged abruptly, it could become damaged. Damaged plugs
or cords can cause an electrical or fire hazard.
• When moving the printer after use, do not take out any of the Toners, Photo
Conductor Units, nor the Waste Toner Cartridge to prevent toner spill inside
the machine.
• Risk of explosion if battery is replaced by an incorrect type. Dispose of used
batteries according to the instructions.
Note
❒ Under certain temperature and humidity conditions, printing may cause va-
pour to issue from paper. The standard tray (behind the control panel) may
emit steam during printing.
❒ Our products are engineered to meet the highest standards of quality and
functionality. When purchasing expendable supplies, we recommend using
only those specified by an authorized dealer.
Important
❒ Rating voltage of the connector for options: Max. DC 24 V.
❒ Voltage must not fluctuate more than 10%.
4