Ricoh SP C400DN User Manual page 108

Paper and Other Media
Envelopes
Printer setup
Printer driver setup
Enabled paper feeding tray Any input tray can be used.
Duplex printing
Additional cautions
5
Note
❒ If the printing result is badly wet or smudged, change the setting on the
printer's control panel as the following:
• Press the {Menu} key, select [Maintenance], [General Settings], and then select
[Envelope]. Select one from [Envelope 1], [Envelope 2], [Envelope 3], or [Enve-
lope 4].
The greater number corresponds to the thicker setting.
The one of these items is normally detected automatically according to the
paper type you set. It is not necessary to change this setting when the print-
ing result has no problem.
86
Make the following settings using the control panel:
• Press the {Menu} key, select [Paper Input], and then select [Enve-
lope] for the selected tray's paper type.
Select [Envelope] in the [Paper type:] list.
Make sure paper is not stacked higher than the upper limit mark
(T) inside the tray. Make sure paper is not stacked higher than the
paper guides inside the bypass tray.
Not possible
• If printed envelopes come out badly creased, load the enve-
lopes in the opposite direction. Also, configure the printer
driver to rotate the print object 180 degrees.
• Load envelopes print side down on the bypass tray.
• Load envelopes print side up in the input tray or optional pa-
per feed unit.
• Check there is no air in the envelopes before loading.
• For better print quality, we recommend the right, left, top, and
bottom print margins to be at least 20 mm (0.8 ") each.
• Load only one size and type of envelope at a time.
• Before loading envelopes, flatten their leading edges (the edge
going into the printer) by running a pencil or ruler across
them.
• Some kinds of envelope might cause misfeeds, wrinkles or
print poorly.
• Print quality on envelopes may be uneven if parts of an enve-
lope have differing thicknesses. Print one or two envelopes to
check print quality.
• In a hot and humid environment, the envelope might be out-
put creased or improper printing quality.