Lexmark MX410 series User Manual page 242

Troubleshooting
Memory full, cannot print faxes
From the printer control panel, select Continue to clear the message without printing. For non‑touch‑screen printer
models, press to confirm.
Note: Held faxes will attempt to print after the printer restarts.
Memory full, cannot send faxes
1
From the printer control panel, select Continue to clear the message and cancel the fax job. For non‑touch‑screen
printer models, press
2
Do either of the following:
•
Reduce the fax resolution, and then resend the fax job.
• Reduce the number of pages in the fax, and then resend fax job.
Network [x] software error [54]
Try one or more of the following:
• From the printer control panel, select Continue to continue printing. For non‑touch‑screen printer models, press
to confirm.
• Turn off the printer, wait for about 10 seconds, and then turn the printer back on.
•
Update the network firmware in the printer or print server. For more information, visit the Lexmark support Web
site at http://support.lexmark.com.
No analog phone line connected to modem, fax is disabled.
Connect the printer to an analog phone line.
Non‑Lexmark [supply type], see User's Guide [33.xy]
Note: The supply type can be toner cartridge or imaging unit.
The printer has detected a non‑Lexmark supply or part installed in the printer.
Your Lexmark printer is designed to function best with genuine Lexmark supplies and parts. Use of third-party supplies
or parts may affect the performance, reliability, or life of the printer and its imaging components.
All life indicators are designed to function with Lexmark supplies and parts and may deliver unpredictable results if
third-party supplies or parts are used. Imaging component usage beyond the intended life may damage your Lexmark
printer or associated components.
Warning—Potential Damage: Use of third-party supplies or parts can affect warranty coverage. Damage caused by
the use of third-party supplies or parts may not be covered by the warranty.
To accept any and all of these risks and to proceed with the use of non-genuine supplies or parts in your printer, press
and hold and the # button on the printer control panel simultaneously for 15 seconds.
to confirm.
242