Setting Up The Digital Scanner; Installing The Interface Cable - Symbol DS4308 Product Reference Manual

Setting Up the Digital Scanner

Installing the Interface Cable

Insert the interface cable modular connector into the interface cable port on the rear of the digital scanner
1.
until you hear a click. For the DS4308P, tip the scanner forward in its base to best access the port.
Low/medium/high beeps sound, indicating the scanner is operational.
Installing the Cable - DS4308 and DS4308P
Figure 1-2
IMPORTANT Insert the cable into the cable interface port until a click sounds.
Gently tug the cable to ensure the connector is secure.
2.
Connect the other end of the interface cable to the host (see the specific host chapter for information on
3.
host connections).
Cable interface port
Interface cable modular
connector clip
Interface cable
modular connector
To host
When connecting the DS4308 using a USB cable, a shielded connector cable is required (e.g., p/n
CBA-U21-S07ZAR). If upgrading an LS2208 or LS4208 to a DS4308, use the shielded connector
cable.
Getting Started 1 - 3