Setting Up The Digital Scanner; Installing The Interface Cable; Removing The Interface Cable - Symbol DS 6608 Product Reference Manual

1-4 DS 6608 Product Reference Guide

Setting Up the Digital Scanner

Installing the Interface Cable

1. Plug the interface cable modular connector into the cable interface port on the bottom of the scanner handle. (See
2.)
2. Gently tug the cable to ensure the connector is properly secured.
3. Connect the other end of the interface cable to the host (see the specific host chapter for information on host connections).
Different cables are required for different hosts. The connectors illustrated in each host chapter are
examples only. Connectors vary from those illustrated, but the steps to connect the digital scanner remain
Note
the same.

Removing the Interface Cable

1. Using the tip of a screwdriver, depress the cable's modular connector clip.
2. Carefully slide out the cable.
3. Follow the steps for
Clip
To host
Figure 1-2. Installing the Cable
Figure 1-3. Removing the Cable
Installing the Interface Cable on page 1-4
Cable interface port
Interface cable modular connector
to connect a new cable.
Figure 1-