Setting Up The Scanner; Installing The Interface Cable - Symbol LS 4008i Product Reference Manual

Setting Up the Scanner

Installing the Interface Cable

1. Plug the interface cable modular connector into the cable interface port on the
bottom of the scanner handle. (See
2. Gently tug the cable to ensure the connector is properly secured.
3. Connect the other end of the interface cable to the host (see the specific host
chapter for information on host connections).
Note: Different cables are required for different hosts. The connectors
illustrated in each host chapter are examples only. Your connectors
may be different than those illustrated, but the steps to connect your
scanner remain the same.
Cable interface
port
Figure 1-2. Installing the Cable
Figure 1-2.)
Interface cable modular
connector
To host
Getting Started
1-3