User-Programmable Supplementals; Upc/Ean/Jan Supplemental Redundancy - Symbol DS4308 Product Reference Manual

User-Programmable Supplementals

Supplemental 1: Parameter # 579 (SSI # F1h 43h)
Supplemental 2: Parameter # 580 (SSI # F1h 44h)
If you selected a Supplemental User-Programmable option from
page 11-12, select User-Programmable Supplemental 1 to set the 3-digit prefix. Then select the 3 digits
using the numeric bar codes beginning on
second 3-digit prefix. Then select the 3 digits using the numeric bar codes beginning on
is 000 (zeroes).
User-Programmable Supplemental 1

UPC/EAN/JAN Supplemental Redundancy

Parameter # 80 (SSI # 50h)
If you selected Autodiscriminate UPC/EAN/JAN Supplementals, this option adjusts the number of times to
decode a symbol without supplementals before transmission. The range is from two to thirty times. Five or
above is recommended when decoding a mix of UPC/EAN/JAN symbols with and without supplementals. The
default is 10.
Scan the bar code below to set a decode redundancy value. Next, scan two numeric bar codes in
Numeric Bar Codes. Enter a leading zero for single digit numbers. To correct an error or change a selection,
scan Cancel on page
UPC/EAN/JAN Supplemental Redundancy
page G-1.
G-2.
Decode UPC/EAN/JAN Supplementals on
Select User-Programmable Supplemental 2 to set a
User-Programmable Supplemental 2
Symbologies 11 - 15
page G-1. The default
Appendix G,