Ricoh 7025 Operating Instructions Manual page 239

Problem
Misfeeds occur frequently.
Misfeeds occur frequently.
Copy paper becomes creased. The paper is damp.
Copy paper becomes creased. The paper is too thin.
There is considerable delay
between the print start in-
struction and actual printing.
There is considerable delay
between the print start in-
struction and actual printing.
❖ Other printing problems
Problem
Duplex printing is malfunc-
tioning.
Duplex printing is malfunc-
tioning.
Duplex printing is malfunc-
tioning.
If the problem cannot be solved, contact your sales or service representative.
Cause
The copy paper is wrinkled or
has been folded/creased.
Printed paper is being used.
"Off mode" might be set.
Processing time depends on
data volume. High volume
data, such as graphics-heavy
documents, takes longer to
process.
Cause
Duplex printing cannot be
done with paper set in the by-
pass tray.
You have loaded thick paper
specified as the paper type.
Duplex printing cannot be
done with a tray for which
[Thick] has been specified as
Paper Type on the System Set-
tings menu.
The Printer Function
Solution
Use recommended paper. Use
paper that has been stored in
the recommended tempera-
ture and humidity condition.
See "Copy Paper", About This
Machine.
Use recommended paper. See
"Copy Paper", About This
Machine.
Use paper that has been
stored in the recommended
temperature and humidity
condition. See "Copy Paper",
About This Machine.
Use recommended paper. See
"Copy Paper", About This
Machine.
The machine requires time to
warm up if it has been in "Off
mode". Specify "Off mode" in
[System Settings], [Auto Off Tim-
er].
If the Data In indicator is
blinking, data has been re-
ceived by the machine. Wait
for a while.
Solution
When using duplex printing,
make settings to use paper
from a tray other than the by-
pass tray.
Specify another paper type.
Change the Paper Type set-
ting for the tray to [No Display
(Plain Paper)] on the System
Settings menu. See "System
Settings", General Settings
Guide.
6
81