User Set Mode; Scrambler Function; Stun Function - Icom IC-F3162DT Instruction Manual

■ User Set mode

The User Set mode can be accessed with the Power ON func-
tion. In this case, all set mode items are available.
The User Set mode allows you to set seldom-changed set-
tings and you "customize" the transceiver operation to suit
your preferences and operating style.
NOTE: While in the Uesr Set mode, [Side2] or [Side3] and
[P0] activate regardless of the assigned key functions.
Entering the User Set mode:
q While holding down [P1] and [P2], rotate [VOL] to turn the
power ON.
• Turn the power OFF first.
• You should hold down [P1] and [P2] until "SET MODE" appears
on the display.
w Hold down [P0] for 1 second to enter the User Set mode.
e Push [P0] several times to select the appropriate item.
Then, push [Side2] or [Side3] to set the desired level or seting.
• Available User Set mode items are Backlight, LCD contrast,
Beep, Beep Level, Ringer Level, SQL Level, AF Min Level,
Mic Gain, VOX Gain*, VOX Delay*, Battery Voltage, Signal
Moni, Lone Worker and System Info.
* Appears only when the external VOX unit is connected.
r Hold down [P0] again to exit the set mode.
The User Set mode is also available using a programmable
key. Please refer to page 10 [User Set Mode] section.
[User Set Mode] allows for quick item selection. Set "Enable"
for the often used items using the CS-F3160/F5060 (dPMR)
. Ask your dealer for details.
cloning software

■ Scrambler function

The Voice Scrambler function provides private communication
between stations. All versions have a built-in frequency inver-
sion type scrambler. Moreover, an optional Rolling or Non-
rolling type can be used.
➥ Push [Scrambler] to turn the Voice Scrambler function ON
or OFF.
• " " appears when the function is ON.

■ Stun function

The dispatcher can send a signal that will stun, kill or revive
your transceiver.
When a Stun command is received, the transceiver becomes
unusable. In that case, receiving a Revive command or input-
ting the password* (p. 11) is necessary to operate the trans-
ceiver again.
When a Kill command is received, the transceiver becomes
unusable (the transceiver switches to the cloning required
condition). In that case, cloning the transceiver is necessary
to operate the transceiver again.
* Depending on the pre-programmed settings.
See the operating guide for details of the Stun function with
the BIIS and dPMR system operations. Ask your dealer for
details.
3
BASIC OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
16