Icom IC-F3162DT Instruction Manual page 14

2
PANEL DESCRIPTION
TALK AROUND "TA"
Push to turn the Talk Around function ON or OFF.
Talk Around
• The function equalizes the transmit frequency to the
receive frequency for transceiver-to-transceiver communication.
WIDE/NARROW "W/N"
Push to switch the IF bandwidth between wide and narrow.
• The wide passband width is pre-programmed to either 25.0 or 20.0 kHz
by your dealer (PMR operation only).
DTMF AUTODIAL "DTMA"
Push to enter the DTMF channel selection mode, then push
[CH Up] or [CH Down] to select a desired DTMF channel.
After selecting, push again to transmit the selected DTMF
code.
RE-DIAL "DTMR"
Push to transmit the last-transmitted DTMF code.
• TX memories are cleared after turning the power OFF.
HIGH/LOW "H/L"
Push to select the transmit output power level temporarily or
permanently, depending on the pre-programmed settings.
• Ask your dealer for the output power level for each selection.
LIGHT "LIGT"
Push to turn the backlight ON for about 5 seconds, when the
Backlight function is set to "OFF" in the User Set mode.
9
CALL, CALL A, CALL B "CALL" "CALA" "CALB"
Push to transmit a 2/5-tone code or BIIS/dPMR call.
• Call transmission is necessary before calling another station,
depending on your signalling system.
• [Call A] and/or [Call B] may be available when your system employs
selective 'Individual/Group' calls. Ask your dealer which call is
assigned to each key.
EMERGENCY "EMR"
Hold down for the pre-programmed time period to enter the
emergency mode. After the pre-programmed time period, an
Emergency call is transmitted once, or repeatedly.* (p. 17)
• To exit the emergency mode, hold down this key for the pre-pro-
grammed time period again, before transmitting.
* Depending on the pre-programmed settings.
SURVEILLANCE "SURV"
Push to turn the Surveillance function ON or OFF.
When this function is turned ON, the beep does not sound
and the LCD backlight and BUSY/TRANSMIT indicator do
not light, even when a signal is received or a key is pushed.
TX CODE ENTER "TXCE"
Push to enter the TX code edit mode (5Tone) (p. 15) or the
ID code edit mode (BIIS, dPMR), and then set the desired TX
code or ID code.