Table of Contents
Advertisement
3
BASIC OPERATION
D DTMF transmission
If the transceiver has [DTMF Autodial] assigned to it, the automatic
DTMF transmission function is available. Up to 8 DTMF channels
are available.
q Push [DTMF Autodial]— a DTMF channel appears.
w Push [CH Up] or [CH Down] to select the desired DTMF channel.
e Push [DTMF Autodial] to transmit the DTMF code to the selected
DTMF channel.
I User set mode
User set mode is accessed at power ON and allows you to set sel-
dom-changed settings. In this case you can "customize" the trans-
ceiver operation to suit your preferences and operating style.
Entering the user set mode:
q While pushing and holding [
ON.
• Turn power OFF in advance.
• "SET MODE" appears for 1 sec.
w Push and hold [P0] for 1 sec. to enter user set mode.
e Push [P0] momentarily to select the appropriate item.
Then push [
] or [
• Available set mode functions are Backlight, Beep, SQL Level,
Ringer Level, AF Min level, Mic Gain, VOX Gain*, VOX Delay*,
Battery Voltage, Signal Moni, Vibration and Lone Worker.
r Push and hold [P0] again to exit set mode.
* Appears when the optional headset is connected.
User set mode is also available using a programmable key. Please
refer to p. 13 [User Set Mode] section.
NOTE: [
], [
] and [P0] activate while in the user set mode
regardless of the assigned key functions.
20
] and [
], rotate [VOL] to power
] to set the desired level/condition.
I Emergency transmission
When [Emergency] is pushed, an emergency signal is automatically
transmitted for the specified time period.
When [Emergency] is pushed for the specified time period, the
DTMF emergency signal is transmitted once or repeatedly on the
emergency channel. However, when no emergency channel is
specified, the signal is transmitted on the previously selected chan-
nel.
If you want to cancel the emergency call, push and hold the key
again before transmitting the call.
I Scrambler function
The scrambler function provides a private communication between
stations with the same scrambler codes.
q Push [Scrambler] to turn the scrambler function ON.
• " " appears.
w Push [Scrambler] again to turn the scrambler function OFF.
I Stun function
When the specified ID, set as a killer ID, is received, the stun func-
tion is activated.
When the killer ID is received, the transceiver switches to the pass-
word required condition. Entering of the password via the keypad is
necessary to operate the transceiver again in this case.
3
BASIC OPERATION
3
21
Advertisement
Table of Contents
