D-Link DSL-302G User Manual page 89

14. A window should pop up indicating "New Port Detected". It will be a port of type "Ethernet Adaptor"
and its interface name "en<N>" will be displayed as well. (i.e.: "Ethernet Adaptor en1"). Click "OK".
15. From the "Show" pull down menu, select the new port (i.e.: "Ethernet Adaptor en1").
16. Select the "TCP/IP" tab. From "Configure" menu, select "Using DHCP" or the way you would like to
obtain an IP address.
17. Click "Apply Now". Wait for a minute.
18. Close the System Preferences application. The installation of DSL-302G is done and now you need to
configure your ADSL account username and password into the DSL-302G.
19. Open the Internet Explorer. Enter the address http://10.1.1.2/ and a window will pop up asking for User
ID and Password. This is the user ID to get into the DSL-302G (this is not your ADSL account details).
Enter "admin" (without the quote) into both User ID and Password boxes, and click "OK".
20. Under "Quick Configuration" page, from "Refresh Rate" pull down menu, select "No Refresh".
21. Enter your ADSL account details into "Username" (eg. user@isp.com.au) and "Password" boxes.
22. Click "Save & Reboot". Wait for a minute or so.
23. You might need to refresh the "Quick Configuration" page. Select "Refresh Rate" back to "5 Seconds"
and you could check your "Connection Status" at the bottom of the "Quick Configuration" page. If it
shows "Connected", you are now connected to the Internet; else check all the cable connections,
username and password again (steps 20 to 22). If you have further enquiry, please contact your ADSL
service provider.
Ethernet Installation
1. If you prefer to use Ethernet connection (instead of USB), you could simply connect up the Ethernet
and DSL lines (not USB) to the DSL-302 modem.
2. In Network Preferences, on "Show" menu, select "Built-in Ethernet".
3. Under "TCP/IP" tab, on "Configure" menu, select "Using DHCP".
4. Click "Apply Now". Wait for a minute.
5. Open the Internet Explorer. Enter the address http://10.1.1.1/ and a window will pop up asking for User
ID and Password. Enter "admin" (without the quote) into both User ID and Password boxes, and click
"OK".
6. Follow the steps 20 to 23 given above.
DSL-302G ADSL Modem User's Guide
6