D-Link DSL-302G User Manual page 15

14. Under the User Details menu tab, please check your ADSL account username and password is correct
as per step 12. If not, please re-enter these and then click 'Save'. The device will reboot itself after
saving.
15. You should now be successfully connected to your ADSL Service provider. Please launch your Web
Browser and test by going to http://www.dlink.com.au
Using the Web Browser
To configure settings you must now access the configuration manager using your web browser. This is done by
entering the IP address in the Address bar of the browser window as follows:
1. If you wish to access the configuration software through the Ethernet port, enter http://10.1.1.1 (default
Ethernet IP address of the DSL-302G).
2. If you wish to access the configuration software through the USB port, double-click on the icon below
or enter http://10.1.1.2 (default USB IP address of the DSL-302G).
3. Press the Enter key and the following prompt will appear:
Be sure that the web browser on your computer is not configured to use a proxy server
in it's Internet settings. In Windows Internet Explorer, you can check if a proxy server is
enabled using the following procedure:
Note
DSL-302G ADSL Ethernet Modem User's Guide
1. In Windows, click on the START button, go to Settings and choose Control
Panel.
2. In the Control Panel window, double-click on the Internet Options icon.
3. Select the Connections tab and click on the LAN Settings button.
4. Verify that the "Use proxy server" option is NOT checked. If it is checked, click
in the checkbox to deselect the option and click OK.
9