D-Link DSL-302G User Manual page 42

Hide thumbs Also See for DSL-302G:

Table of Contents

DSL-302G ADSL Modem User's Guide

Configuring the Modem for IPoA Mode

To configure the DSL-302G ADSL modem to operate in Internet Protocol over ATM (IPoA) mode, follow these

instructions.

Open the WAN folder and then click on the IPOA link.

This will open the IP over ATM (IPoA)

Configuration menu, as shown below.

Click the Add button to open the IPoA Interface – Add menu, as shown below.

Enter the IPoA configuration information supplied to you by your ADSL service provider. In the example

above, the ADSL service provider assigned an IP address of 203.1.1.2, a netmask of 255.255.255.252, and a

gateway IP address of 203.1.1.1. Click the Submit button to make the change current. A confirmation screen

will appear to confirm the changes. Close the IPoA Interface – Add menu.

Now open the WAN folder (if it is not already open) and click the IPoA link. The newly created IPoA interface

will now be displayed, as shown below.

Table of Contents