Summary Of Welding Processes - Lincoln Electric RANGER SVM120-A Service Manual

B-13
SUMMARY OF WELDING
PROCESSES AND MACHINE
SETTINGS
Table B.3 summarizes the requirements for various
welding processes you can perform with the
RANGER 10-LX.
Process Control
Cable
Used
Stick – CC No
TIG - CC Yes
K930-1/K936-1
(With Amptrol)
Wire Feed - CV, Yes
LN-25 with 42V
Remote Control Kit
Wire Feed - CV No
LN-25 with internal
contactor
Wire Feed - CV, Yes
LN-7 or LN-8
OPERATION
TABLE B.3 - SUMMARY OF WELDING PROCESSES
Idle Output
Mode Control
Switch
Auto At Welder
Auto Remote
Auto Remote
Auto At Welder
High Remote
RANGER 10-LX
Wire Electrode
Feeder State When
Switch Not Welding
No Hot
Control
Cable
With Cold
Control
Cable
With Cold
Control
Cable
No Cold
Control
Cable
With Cold
Control
Cable
B-13
To Start Welding
Touch electrode to work.
Welding starts immed-
ately and engine goes to
high idle.
Press Amptrol. Welding
starts immediately.
Press gun trigger,
RANGER 10-LX contactor
closes. Welding starts
immediately and engine
goes to high idle.
Press gun trigger, LN-25
contactor closes. Weld-
ing starts immediately
and engine goes to high
idle.
Press gun trigger,
RANGER 10-LX contactor
closes. Welding starts
immediately.