Electrical Output Connections; Muffler Relocation; Spark Arrester - Lincoln Electric RANGER 9 SVM 110-A Service Manual

A-5
90
1 RANGE 125
70
175
50
16 to 25
WARNING
LINCOLN
ELECTRIC
7
6
9

MUFFLER RELOCATION

WARNING
Shut off the machine and allow the muffler to cool
before touching the muffler.
The RANGER 9 is shipped with the exhaust coming
out on the left side. It can be changed to the right side
by removing two screws that hold the exhaust port
cover in place and installing the cover on the opposite
side.
NOTE: Operating the RANGER 9 without the cover in
place will not increase the machine output and
will result in a higher noise level.

SPARK ARRESTER

Gasoline engine mufflers may emit sparks when the
engine is running. Some federal, state, or local laws
require spark arresters in locations where unarrested
sparks could present a fire hazard.
RANGER 9
INSTALLATION
FIGURE A.1 - RANGER 9 OUTPUT CONNECTIONS
2 3 4
6
5
7
4
3 8
2
DC+
9
AC DC-
1
10 max
225 AC
210 DC
RANGER 9
CHOKE
AUTO
START
RUN
IDLER
STOP
HIGH
8
5
1. OUTPUT RANGE SELECTOR
2. FINE OUTPUT CONTROL
3. CONTROL AT WELDER/REMOTE CONTROL SWITCH
4. WELDING TERMINALS SWITCH
5. POLARITY SWITCH
6. 115/230 VOLT, 50 AMP RECEPTACLE
7. 115 VOLT, 20 AMP RECEPTACLES (2)
8. WELD OUTPUT TERMINALS (2)
9. GROUND STUD
Standard mufflers and deflectors (like the ones includ-
ed with the RANGER 9) do not act as spark arresters.
When local laws require it, a spark arrester must be
installed on the machine and properly maintained. An
optional spark arrester kit (K894-1) is available for your
RANGER 9. See the Accessories section of this man-
ual for more information.
CAUTION
An incorrect spark arrester may lead to damage to the
engine or reduce performance.
ELECTRICAL OUTPUT
CONNECTIONS
See Figure A.1 for the location of the output range
selector, fine output control, polarity switch, control at
welder/remote control switch, welding terminals
always on/remotely controlled switch 115 and 230 volt
receptacles, weld output terminals, and ground stud.
A-5
RANGER 9