Summary Of Welding Processes; Dc Wire Feed Welding - Lincoln Electric RANGER 9 SVM 110-A Service Manual

B-13
SUMMARY OF WELDING
PROCESSES AND MACHINE
SETTINGS
Table B.3 summarizes the requirements for various
welding processes you can perform with the
RANGER 9.
Process Control
Cable
Used
Stick – CC No
TIG - CC Yes
K930-1/K936-1
(With Amptrol)
Wire Feed - CV, Yes
LN-25 with 42V
Remote Control Kit
Wire Feed - CV No
LN-25 with internal
contactor
Wire Feed - CV Yes
LN-742
Wire Feed - CV, Yes
LN-7
RANGER 9
OPERATION
TABLE B.3 - SUMMARY OF WELDING PROCESSES
Idle Output
Mode Control
Switch
Auto At Welder
Auto Remote
Auto Remote
Auto At Welder
Auto Remote
High Remote
Welding Electrode
Terminals State When
Switch Not Welding
Always on Hot
Remote Cold
Remote Cold
Always on Cold
Remote Cold
Remote Cold
B-13
To Start Welding
Touch electrode to work.
Welding starts immedi-
ately and engine goes to
high idle.
Press Amptrol. Welding
starts immediately.
Press gun trigger,
RANGER 9 contactor
closes. Welding starts
immediately and engine
goes to high idle.
Press gun trigger, LN-25
contactor closes. Weld-
ing starts immediately
and engine goes to high
idle.
Press gun trigger,
RANGER 9 contactor
closes. Welding starts
immediately and engine
goes to high idle.
Press gun trigger,
RANGER 9 contactor
closes. Welding starts
immediately.
RANGER 9