Generic Trigger X 50ccm Owner's Manual page 43

3.3.2.3 Inspect the front wheel bearing
Middle sleeve of front wheel
Disassemble the middle sleeve of front wheel and remove
the oil seal.
oil seall
clearance
Inspect rolling condition of the inner race of swivel bearing
clearance
If it does not roll or is loosely contacted with the outer race
or it is damaged, please replace with a new one.
axial direction
radial direction
3.3.2.4 Inspect the spoke
Inspect the spoke ， if it is bent, damaged, please change it .
If it is relaxed, please fasten it.
Screw up the spoke with the tightening torque on screw cap
of 0.3× 10 N·m.
3.3.3 Replace the bearing
Unload the front wheel spindle and the sleeve.
Spread grease on the bearing.
Punch in the left bearing.
Reload the sleeve.
Punch the bearing in.
* Note
•The bearing must be punched in
horizontally.
•The oil seal must be punched outward.
- 42 -