Head Restraints - Skoda Octavia Owner's Manual

Reducing or increasing the curvature of the lumbar support
›
Push the switch » Fig. 47 in the region of one of the arrows 2.
A
Raising or lowering the curvature of the lumbar support
›
Push the switch » Fig. 47 in the region of one of the arrows 1.
A
The adjusted driver's seat position can be set in the memory of the
seat » page 66 or the remote control key
Note
If the setting procedure is interrupted, you will need to press the button again.

Head restraints

Fig. 49 Head restraint: front/rear

First read and observe the introductory information and safety warn-
ings on page 63.
Setting height
›
Hold the front head restraints on the sides with both hands, press and hold the
safety button » Fig. 49 and move the head restraints into position.
A
›
Hold the rear head restraints on the sides with both hands and move them up-
wards » Fig. 49.
To move the head restraint downwards, press and hold the safety button
one hand and press the head restraint downwards with the other hand.
Removing/installing
Only the real head restraints may be removed.
›
Pull the head restraint out of the seat backrest as far as the stop.
» page 66.
1
›
Press the locking button in the direction of arrow
press the locking button into the opening
width of maximum 5 mm and pull out the head restraint.
›
To re-insert the head restraint, push it far enough down into the seat backrest
until the locking button clicks into place.
Best protection is achieved if the top edge of the head restraint is at the same
level as the upper part of your head.
The head restraints must be adjusted to match the size of the seat occupant. Cor-
rectly adjusted head restraints together with the seat belts offer effective protec-
tion for the occupants » page

WARNING
The head restraints must be correctly adjusted in order to offer effective
■
protection for the occupants in the event of an accident.
Never drive with the head restraints removed - risk of injury.
■
If the rear seats are occupied, the rear head restraint must not be in the
■
lower position.
Note
The middle rear head restraint is only adjustable in two positions.
with
» Fig. 49, simultaneously
1
using a flat screwdriver with a
2
159, Proper seated position.
Seats and useful equipment

65