Rear Seat Backrest With Through-Loading Channel - Skoda Octavia Owner's Manual

LED display
›
Permanent green light: The power socket is activated.
›
Flashing red light: The power socket is temporarily deactivated.
The power socket is deactivated automatically when the amperage is too high,
the temperature is too high or the battery charge state is too low.
When the reasons for the deactivation no longer apply, the power socket will be
re-activated automatically. Then re-activate connected devices which are switch-
ed on » .
WARNING
The power socket can only be used for connecting approved electrical ac-
■
cessories with a two-pin 230V plug, with a total power uptake of up to
150 watt.
The power sockets- and thus the connected electrical devices -only oper-
■
ates if the ignition is switched on!
Improper use can lead to serious injury or fire. Therefore never leave chil-
■
dren unattended in the vehicle – risk of injury!
Safely stow away all connected devices during the journey to prevent them
■
from being thrown around the interior in the event of a sudden braking ma-
noeuvre or an accident – risk of death!
Do not pour liquids into the power socket – risk of death! If fluid does man-
■
age to get into the power socket, completely dry out the socket before reuse.
The connected appliances may behave differently to when connected to the
■
mains.
The connected devices may warm up during operation – risk of injury or fire!
■
The child lock on the 230 Volt power socket is unlocked when using ener-
■
gised adapters and extension cables – risk of injury!
Do no insert any conductive objects into the contacts of the power socket,
■
e.g. knitting needs – risk of death!
CAUTION
Place the connector on the electrical device into the power socket as far as it
■
can go to create a connection between the contacts.
If the connector of the electrical device is not inserted fully into the power sock-
■
et, the child safety lock might release, and the power socket be activated. The
electrical device is nevertheless not connected.
The 230-volt power socket is temporarily disabled when the engine starts and
■
the LED flashes red. After starting the engine, the power socket is re-activated
automatically.
78
Using the system
Do not connect any lamps with neon filaments to the 230 V power socket - risk
■
of damaging the lamp.
A larger current surge may arise in some power supplies (e.g. for notebooks)
■
when connecting them to a 230 V power socket- this will automatically deacti-
vate the power socket. In this case, disconnect the power supply from the con-
sumer and connect the power supply to the power socket first, followed by the
consumer.
Observe the operating instructions for the connected devices!
■

Rear seat backrest with through-loading channel

Fig. 74 Rear seats: Cover handle/boot: Unlock button

First read and observe the introductory information and safety warn-
ings on page 70.
After folding the rear armrest and cover up, an opening in the seat backrest be-
comes visible through which the removable through-loading bag with skis can be
pushed. The armrest and cover can be folded forward from the passenger com-
partment or the boot.
Opening from the passenger compartment
›
Fold the rear armrest dow (not as far as the stop)
›
Pull the handle » Fig. 74 in the direction of the arrow and fold the cover
A
downwards.
Opening from the boot
›
Push the unlock button » Fig. 74
B
cover including the armrest forwards.
» page 68.
in the direction of the arrow and fold the

