Sealing And Inflating The Tyre - Skoda Octavia Owner's Manual

Sealing and inflating the tyre


First read and observe the introductory information and safety warn-
ings on page 219.
Sealing
›
Forcefully shake the tyre inflator bottle
›
Firmly screw the inflation hose
3
The film on the cap is pierced automatically.
›
Remove the plug from the inflation hose
the tyre valve.
›
Hold the bottle with the bottom facing upwards and fill all of the sealing
10
agent from the tyre inflator bottle into the tyre.
›
Remove the empty tyre inflator bottle from the valve.
›
Screw the valve core back into the tyre valve using the valve remover
Inflating
›
Screw the tyre inflation hose » Fig. 194
5
firmly onto the tyre valve.
›
Check that the air release valve
7
›
Start the engine and run it in idle.
›
Plug the connector into 12 Volt socket
9
›
Switch on the air compressor with the ON and OFF switch
›
Allow the air compressor to run until a pressure of 2.0 - 2.5 bar is achieved. Max-
imum run time of 8 minutes » !
›
Switch off the air compressor.
›
If you cannot reach an air pressure of 2.0 – 2.5 bar, unscrew the tyre inflation
hose from the tyre valve.
5
›
Drive the vehicle 10 metres forwards or backwards to allow the sealing agent to
"distribute" in the tyre.
›
Firmly screw the tyre inflation hose
inflation process.
›
If you cannot reach the required tyre inflation pressure here either, this means
the tyre has sustained too much damage. You cannot seal with tyre with the
breakdown kit » .
›
Switch off the air compressor.
›
Remove the tyre inflation hose
5
Once a tyre inflation pressure of 2.0 – 2.5 bar is achieved, continue the journey at
a maximum speed of 80 km/h.
Check the tyre inflation pressure after driving for 10 minutes
» Fig. 194 on page 220 several times.
10
onto the tyre inflator bottle clockwise.
10
and plug the open end fully onto
3
on page 220 of the air compressor
is closed.
» page 74.
.
8
back onto the tyre valve and repeat the
5
from the tyre valve.
» page 221.
WARNING
During inflation, the tyre inflation hose and air compressor may get hot –
■
risk of injury!
Do not place the hot tyre inflation hose or hot air compressor on flammable
■
materials – risk of fire!
If you cannot inflate the tyre to at least 2.0 bar, this means the damage sus-
■
tained was too serious. The sealing agent cannot be used to seal the tyre.
Do not drive the vehicle! Seek help from a ŠKODA specialist garage!
CAUTION
Switch off the air compressor after running 8 minutes at the latest – risk of over-
heating! Allow the air compressor to cool a few minutes before switching it on
.
1 again.
Checking after 10 minutes

First read and observe the introductory information and safety warn-
ings on page 219.
Check the tyre inflation pressure after driving for 10 minutes!
If the tyre inflation pressure is 1.3 bar or less
›
Do not drive the vehicle! You cannot properly seal with tyre with the break-

down kit.
›
Seek help from a ŠKODA specialist garage.
If the tyre inflation pressure is 1.3 bar or more
›
Adjust the tyre inflation pressure to the correct value (see inside of fuel filler
cap).
›
Continue driving carefully to the nearest ŠKODA specialist garage at a maximum
speed of 80 km/h.
Emergency equipment, and self-help



221