Toshiba MMU-AP0074YH-E Service Manual page 60

◆ Changing the indoor unit address using a remote controller
To change an indoor unit address using a wired remote controller.
▼ The method to change the address of an individual indoor unit (the indoor unit is paired with a wired
remote controller one-to-one), or an indoor unit in a group.
(The method is available when the addresses have already been set automatically.)
(Execute it while the units are stopped.)
1
Push and hold the
(If 2 or more indoor units are controlled in a group, the first indicated UNIT No. is that of the head unit.)
2
Push the
change if 2 or more units are controlled in a group. (The fan and louvers of the selected indoor
unit are activated.)
(The fan of the selected indoor unit is turned on.)
3
Push the TEMP.
4
Push the TIME
to that you want.
5
Push the button.
6
Push the
change.
4 6
Repeat steps to
7
Push the
8
If the addresses have been changed correctly, push the
Finish
, , and buttons at the same time for more than 4 seconds.
button (left side of the button) repeatedly to select an indoor unit number to
/ buttons repeatedly to select
/ buttons repeatedly to change the value indicated in the SET DATA section
button (left side of the button) repeatedly to select another indoor UNIT No. to
to change the indoor unit addresses so as to make each of them unique.
button (left side of the button) to check the changed addresses.
for CODE No..
button to finish the procedure.
59