Toshiba MMU-AP0074YH-E Service Manual page 139

No. Component
8 Lower panel 1. Removing
Slide it horizontally from the drain pan of the discharge.
Applying excessive force may cause breakage.
2. Attaching
Procedure
1) Perform Step 1 of 1 and Step 1 of 7.
2) For AP024 – AP048, remove the strengthening
metal fittings.
(Ø4 X 12, 1)
Remove the screw on the front, and thread it
through the square hole of the side. For AP015 –
AP018, there is no strengthening metal fitting.
3) Remove the screws from both sides.
(One side: Ø4 X 8, 3)
4) Remove the screw of the fan.
(Ø4 X 8, 3)
5) Slide the lower panel in the discharge direction to
remove it.
NOTE
6) When removing the sensor base, wrap vinyl tape
on the tip of a flat-head driver as shown in the
following picture, and then insert it into the groove
of the side below the sign of the cover.
Flat-head driver
(Wrap vinyl tape)
Vinyl tape
Insert into the groove
of the side below the
sign
1) Slide along the drain pan from the discharge to
attach it.
2) Insert the screws (strengthening metal fittings for
AP024 – AP048) removed in 1.
Back: Insert into
square hole
138
Remarks
Front: Screw end
Strengthening
metal fitting
Screw