Toshiba MMU-AP0074YH-E Service Manual page 140

No. Component
9 Drain pan 1. Removing
When removing the drain cap, put a bucket or the like for
drain water.
2. Attaching
Procedure
1) Perform Step 1 of 1, Step 1 of 7, and Step 1 of 8.
2) Remove the drain cap, and then drain water from
the drain pan.
NOTE
3) Pick the hose band, slide from the drain pan
connection part, and then remove the drain hose.
4) Remove the thermal insulator attached on the
discharge of the drain pan, and then remove the
stepped screw.
AP015 – AP027 One stepped screw
AP036 – AP048 Two stepped screws
The removed thermal insulator is used when
attaching.
5) Slide the drain pan toward the discharge to
remove it.
1) Insert the drain cap deep into the drain pan.
2) Slide from the discharge, and then hook firmly on
the hook part of the board metal on the fan.
3) Insert the stepped screw removed in 1, and attach
the thermal insulator on it.
4) Use the hose band to attach the drain hose
removed in 1.
Drain hose
139
Remarks
Hose band
Stepped screw
Thermal insulator