Table of Contents
Advertisement
30678_KX-TCD705G_a_English
Setting the Handset PIN
You can program a 4 digit password for the handset. The factory pre-set is 0000.
Changing the password may prevent the unauthorised use of your unit by another person.
In the 'Setting Handset' mode
Y or V
S/U
Select
'Other
Option'
NOTE: Once you have programmed the password, you
cannot confirm it. We recommend you write down the
password. If you forget it, please consult your nearest
Panasonic Service Centre.
Registering a Handset to a Base Unit
The handset supplied with the base unit is already registered. If an optional
handset/base unit is purchased, the following procedure needs to be carried out before
initial use.
Z and hold (Ï) on base unit for more than10 seconds. A series of beeps begin
to sound.
In the 'Setting Handset' mode
Y or V
S/U
Select
'Registration'
Enter Base PIN
NOTES:
• Charge the optional handset batteries for about 10 hours before initial use.
• Register the handset number within 1 minute. If not registered within 1 minute,
ZP on the handset to cancel the programming mode. Then re-start registration.
• Calls (both incoming and outgoing) can be conducted only via the displayed base
unit (even if the radio areas overlap with neighbouring base units).
8/5/01
6:58 am
Y or V
S/U
Select
'Change
Hset PIN'
Y or V
S/U
Select
Select Base
'Register
No. to register
handset (1-4).
H/set'
Please Wait...
Y
• If registration is successful, a confirmation tone sounds
and display returns to the standby mode. The selected
base number is displayed in the standby mode.
• If registration is not successful within 5 minutes, an error
tone sounds and display returns to original standby
mode.
Page 41
Enter Old PIN
Enter New PIN
Enter the current
Enter the new 4-digit
4-digit handset
PIN TWICE.
PIN.
If 2nd PIN entry is
incorrect, an error
tone sounds and
display returns to 'New
PIN'. If PIN is correct,
a confirmation tone
sounds.
Y or V
S/U
Handset searches
selected base.
41
Please Wait...
Advertisement
Table of Contents
