Table of Contents
Advertisement
TEMPORARY CONFIDENTIAL
TG933X(e).book Page 29 Wednesday, September 26, 2007 2:00 PM
Registering a handset to a
base unit
The supplied handset and base unit are
pre-registered. When you purchase an
additional handset, refer to the additional
handset's installation manual for
registration. If for some reason the
handset is not registered to the base
unit, register the handset.
1
Handset:
{MENU} i {#}{1}{3}{0}
2
Base unit:
Press and hold
{LOCATOR/INTERCOM} for about
5 seconds, until the registration tone
sounds.
L If all registered handsets start
L After pressing
3
Handset:
Press {OK}, then wait until a long
beep sounds.
ringing, press
{LOCATOR/INTERCOM} to stop,
then repeat this step.
{LOCATOR/INTERCOM}, the
rest of this procedure must be
completed within 90 seconds.
Using Caller ID service
Important:
L This unit is Caller ID compatible. To
use Caller ID features, you must
subscribe to Caller ID service. Contact
your service provider/telephone
company for details.
Caller ID features
When an outside call is being received,
the name and phone number are
displayed.
Caller information for the last 50 callers
is logged in the caller list by the most
recent call to the oldest.
L Generally caller information is
displayed from the 2nd ring.
L If the unit cannot receive caller
information, the following is displayed:
– "Out of area": The caller dialed
from an area which does not
provide Caller ID service.
– "Private caller": The caller
requested not to send caller
information.
– "Long distance": The caller
made a long distance call.
L If the unit is connected to a PBX
system, caller information may not be
received properly. Contact your PBX
supplier.
11
Advertisement
Table of Contents
