Program Upload (Sp5-826) - Ricoh K-C1 Service Manual

USING SERVICE PROGRAM MODES
Display during writing.
Display when the download is
complete.
Display if writing has failed.
NOTE: To view the current firmware version, check SP7-801-1.

Program Upload (SP5-826)

NOTE: Be sure to turn off the main switch before inserting or removing the flash
memory. Installing or removing flash memory while the switch is still on
may result in damage to the BiCU or to the memory.
1. Turn off the main switch.
2. Insert a flash memory card into the card slot (see the previous page).
NOTE: Make sure that the printed "A" on the card is facing the outside of the
machine.
3. Turn on the main switch.
4. Access SP mode 5-826.
5. The machine erases the software on the card, then writes the new software to
the flash memory card. This takes about 60 seconds. If uploading fails, an error
message appears. If this occurs, repeat the upload procedure.
6. Turn off the main switch, then remove the memory card.
Program Download
Load status:2-161402
Program Download
End sum=2A74 0.29EU
Program Download
Loading error!!!
5-42
20 February, 2001
B039M010.WMF
B039M011.WMF
B039M012.WMF