Sp5-Xxx (Mode) - Ricoh K-C1 Service Manual

20 February, 2001

SP5-XXX (Mode)

5
Mode Number/Name
001 All Indicators On
104* A3/DLT Double Count
113* Optional Key Counter
116* Key Counter Timing
120* Key Counter Removal Reset
143*
DF 180° Image Rotation
401* User Code Mode
USING SERVICE PROGRAM MODES
Function/[Setting]
Blinks all indicators on the operation panel.
Press OK or ! to cause all LEDs to begin blinking at a 3-
second cycle. After checking that LEDs are all blinking,
press " or Cancel to exit.
Selects whether the machine counts twice for each sheet
of A3/11"x 17".
[0 = No / 1 = Yes]
If this is set to "Yes" is selected, the total (mechanical)
counter and the current user counter will both increment
by two for each A3/11" x 17" sheet.
Enables/disables the optional key counter.
[0: = None / 1 = Key Counter]
You must set this value to 1 after installing the optional
key counter.
Selects whether the key counter increments at time of
paper feed-in or at time of paper exit.
[0 = Feed In / 1 = Exit]
Determines under which conditions the copy job settings
are reset when the key counter is removed.
With 0, the settings are cleared if the counter is removed
at the end of a job or midway through a job.
With 1, they are only cleared if the counter is removed at
the end of a job.
With 2, they are not cleared at all, under either condition.
[0=Yes / 1=Standby only / 2=No]
With duplex copies, the job settings are always preserved,
regardless of the setting of this SP mode.
Selects whether images copied in DF mode are turned
upside down (rotated 180 degrees).
[0 = No / 1 = Yes]
Select "Yes" when you want the image trailing edge at the
paper's leading edge (e.g., letter-headed copy paper).
Enables/disables the User Code feature for copy mode.
[0 = No / 1 = Yes]
• Changing this value causes the following User Tool
setting to change accordingly: [3. Copier Features] →
• [12. Key Operator Tools] → [1. User Code Access].
• If the customer forgets a user code, you can retrieve it
as follows.
1) Change this SP value from 1 to 0.
2) Use [3. Copier Features] → [12. Key Operator Tools]
→ [3. Print Counter List] to print out the counter list.
3) The list will show all the user codes.
5-17