Input Check (Sp5-803) - Ricoh K-C1 Service Manual

USING SERVICE PROGRAM MODES

5.1.3 INPUT CHECK (SP5-803)

1. Access SP mode 5-803.
2. Select the number that will access the switch or sensor you wish to check (see
the table below).
3. Check the status of the sensor or switch.
4. If you wish to check the signal during a copy cycle, select the required copy
modes, then press !.
5. The LCD panel will display "00H" or "01H", as shown below.
The following table shows the meaning of each of the displayed values.
Number
0 Not used
1 Front/right cover safety switch
2 Front/right cover safety switch
- LD5V
3 Right door switch
4 Vertical transport door switch
5 Tray cover switch
(Optional paper tray unit)
6 – 15 Not used
16 Relay sensor
17 Vertical transport sensor
18 Vertical transport sensor
(Optional paper tray unit)
19 Registration sensor
20 Exit sensor
21 Duplex inverter sensor
22 Duplex entrance sensor
23 Duplex exit sensor
24, 25 Not used
26 By-pass paper end sensor
27 By-pass paper size switch
28 – 30 Not used
31 Upper paper end sensor
Input Check
Code:
Description
0
B039M005.WMF
In #01=00H
B039M006.WMF
00H
Closed
Closed
Closed
Closed
Closed
Paper not detected.
Paper not detected.
Paper not detected.
Paper not detected.
Paper not detected.
Paper not detected.
Paper not detected.
Paper not detected.
Paper not detected.
See Table 3.
Paper not detected.
5-32
20 February, 2001
Reading
01H
Opened
Opened
Opened
Opened
Opened
Paper detected.
Paper detected.
Paper detected.
Paper detected.
Paper detected.
Paper detected.
Paper detected.
Paper detected.
Paper detected.
Paper detected.