Scanning; Registration: Platen Mode - Ricoh K-C1 Service Manual

COPY ADJUSTMENTS: PRINTING/SCANNING

3.13.2 SCANNING

NOTE: 1) Before doing the following scanner adjustments, check and adjust the
printing leading-edge and side-to-side registrations and the printing
blank margins (as described above).
2) Use an A3 test chart to perform the following adjustments.

Registration: Platen Mode

1. Place the test chart on the exposure glass and make a copy from one of the
feed stations.
2. Check the leading edge and side-to-side registration, and adjust as necessary
using the following SP modes.
Leading edge
Side-to-side
SP mode Specification
SP4-010 2 ± 1.5 mm
2 ± 1.5 mm
SP4-011
A: Leading edge registration
B: Side-to-side registration
3-52
20 February, 2001
A
B
A250R515.WMF