Jackson 24A-AF Instruction Manual page 9

5. Using the two holes in bracket #4 as a guide, drill two holes 9/64" diameter in the side panel of
machine. Note: Drill through first thickness of metal only.
6. Using the self-tapping screws supplied, screw them through bracket #4 and into the side panel of
machine until screws are tight.
Removal of Pan Strainer for Cleaning: (Wash and rinse head assemblies must be removed prior to
removing strainer.)
1. Turn machine off and drain by depressing drain switch and releasing.
2. Remove holding pin from rinse feed pipe, remove rinse head assembly by pulling forward.
3. Remove holding pin from upper pump housing, wash head may now be lifted out.
4. Pan strainer now accessible, lift out and clean thoroughly.
5. Clean around pump intake with bristle brush.
6. Replace stainer pan.
7. Re-install wash and rinse head assemblies.
8. Clean strainer pan daily or as needed to insure proper machine operation.
Installation of Wash Head and Rinse Arm Assemblies: (Items disassembled for shipment)
1. Line up stud to match with slot in nipple.
2. Insert rinse arm assembly into female receptical
protruding through back of machine.
3. Insert lanyard pin to secure rinse arm assembly
properly.
4. Make certain end plugs are secured properly in
rinse tubes.
1. Line holes up on wash head assembly to match slots in pump housing.
2. Insert wash head assembly down into upper pump housing as far as
possible.
3. Insert retaining pin to secure wash head to pump housing.