High temperature door
type dishwasher
-warranty policy -basic functions of dishwasher
-installation requirements -maintenance and care
-operating instructions -illustrated parts list
-description of components -electrical diagrams (55 pages)
Page 1
WAREFORCE™ UNDER COUNTER DISH MACHINE SERIES TECHNICAL MANUAL INSTALLATION, OPERATION & TECHNICAL MANUAL ELECTRICALLY HEATED MODELS: WAREFORCE™ UH 30 WAREFORCE™ UL 30 Jackson WWS,INC P.O. Box 1060, Hwy 25E Barbourville, KY USA 1.606.523.9795 March 11, 2013 www.jacksonwws.com P/N 07610-003-67-21 (Revision E)
Page 2
Revision Revision Made By Applicable ECNs Details Letter Date 03-04-09 Release to production 04-21-10 100420-1456-CW Corrected Wire Colors on WF-UH30 Sche- matic 05-05-10 8157 Changed UH Peri-pump assembly 08-22-11 QOF-386 Made strip heater optional 03-11-13 QOF NDB-219 Updated manufacturer information & con- verted to publisher format.
Page 3
WAREFORCE™ UL 30 = Low temperature, chemical sanitizing, no booster tank. Detergent, rinse aid & sanitizer chemical feeder pumps. Jackson WWS, INC provides technical support for all of the dish machines detailed in this man- ual. We strongly recommend that you refer to...
WAREFORCE UH/UL 30 Technical Manual (07610-003-67-21) Operating Parameters Model Designation: WAREFORCE™ UH 30 WAREFORCE™ UL 30 Operating Capacity: Racks per Hour Dishes per Hour Glasses per Hour Tank Capacity (gallons): Wash Tank Rinse Tank Electrical Loads (as applicable): Wash Motor HP 0.75 0.75 Rinse Heater KW...
Work should only be per- formed by qualified electricians and authorized service agents. A list of Jackson Authorized Service Agencies is located in the back of this manual.
UNPACKING THE MACHINE: The machine should be unboxed and/or removed from the pallet prior to installing. Open the front door and remove all of the materials from the inside. Once unpacked, verify there are no missing parts to the best of your ability. If you discover a part is missing, contact Jackson immedi- ately.
Page 12
(1/2” ID pipe size minimum) to the dish machine incoming water connection point using copper pipe (or order the 1/2” ID flexible hose kit offered by Jackson). It is recommended that a water shut off valve be installed in the water line between the main supply and the machine to allow access for service.
Page 13
NOTE: The bottom of the chemical container cannot be located any higher than 8” from the floor. If the unit is equipped with the 6” or 18” table stand, then the highest position will respectively be 14” or 26” from the floor. this, contact Jackson immediately for assistance. Page Created: 03-28-2011...
Page 14
WAREFORCE UH/UL 30 Technical Manual (07610-003-67-21) INSTALLATION INSTRUCTIONS (CONTINUED) TO PREPARE CHEMICAL FEEDER PUMPS FOR OPERATION: The WAREFORCE™ UH 30 dish machine is supplied with integral detergent and rinse aid chemical feeder pumps. The WAREFORCE™ UL 30 dish machine is supplied with integral detergent, rinse additive, and sanitizer chemical feeder pumps.
Page 15
WAREFORCE UH/UL 30 Technical Manual (07610-003-67-21) INSTALLATION INSTRUCTIONS (CONTINUED) PROGRAMMING INSTRUCTIONS FOR CHEMICAL FEEDER PUMPS (INSTALLATION TECHNICIAN ONLY) To access the programming mode, the machine must be ON and idle (between cycles). On the timer board, press and hold both the MOVE and ENTER buttons on the timer board simultane- ously for two seconds.
Page 16
WAREFORCE UH/UL 30 Technical Manual (07610-003-67-21) INSTALLATION INSTRUCTIONS (CONTINUED) PROGRAMMING INSTRUCTIONS FOR CHEMICAL FEEDER PUMPS (CONTINUED) WARE- WARE- TIMER PROGRAMMING BOARD FORCE™ UH FORCE™ UL 30 Not adjustable Rinse Aid TIME IN SECONDS Rinse Fill Detergent Sanitizer Rinse Aid Detergent ACCEPT MOVE ENTER...
Page 17
If the water cannot get hot enough, your results may not be satisfactory. This is why Jackson recommends that if you have installed the machine in an area with hard water, that you also install some type of water treatment equipment to help remove the dissolved solids from the water be- fore it gets to the dish machine.
Page 18
These temperatures may also be followed by temperatures that Jackson recommends to ensure the highest performance from you dish machine. However, if the minimum requirements are not met, the chances are your dishes will not be clean or sanitized.
WAREFORCE UH/UL 30 Technical Manual (07610-003-67-21) OPERATION INSTRUCTIONS PREPARATION: Before proceeding with the start-up of the unit, verify the following: 1. The strainer is in place and is clean. 2. That the wash and rinse arms are screwed securely into place and that their end caps are tight. The wash and rinse arms should rotate freely.
Page 20
WAREFORCE UH/UL 30 Technical Manual (07610-003-67-21) OPERATION INSTRUCTIONS (CONTINUED) WARM-UP CYCLES: For a typical daily start-up, it is recommended to run the machine through 3 cycles to ensure that all of the cold water is out of the system and to verify that the unit is operating correctly. To cycle the machine, ensure that the power is on and that the tub has filled to the correct level.
Page 21
To order a replacement cartridge, call Jackson immediately to have one shipped to you. To proceed with the deliming operation, fill the dish machine and add the correct amount of deliming solution as recommended by the deliming solution manufacturer.
The dish machines covered in this manual are designed to operate with a minimum of interaction with the operator. However, this does not mean that some items will not wear out in time. Jackson highly recommends that any main- tenance and repairs not specifically discussed in this manual should be performed by QUALIFIED SERVICE PER- SONNEL ONLY.
WAREFORCE UH/UL 30 Technical Manual (07610-003-67-21) TROUBLE SHOOTING COMMON PROBLEMS WARNING: Inspection, testing and repair of electrical equipment should be performed only by qualified service per- sonnel. Certain procedures in this section require electrical tests or measurements while power is applied to the machine.
Page 24
WAREFORCE UH/UL 30 Technical Manual (07610-003-67-21) TROUBLE SHOOTING COMMON PROBLEMS (CONTINUED) WARNING: Inspection, testing and repair of electrical equipment should be performed only by qualified service per- sonnel. Certain procedures in this section require electrical tests or measurements while power is applied to the machine.
WAREFORCE UH/UL 30 Technical Manual (07610-003-67-21) RINSE SOLENOID VALVE & VACUUM BREAKER REPAIR PARTS KIT/WATER HAMMER KIT OPTION Screw Cap Screw Data Plate Coil & Housing Data Plate Valve Bonnet Spring & Plunger Kit Spring position is moved 06401-003-07-40 for clarity. Goes below the plunger.
WAREFORCE UH/UL 30 Technical Manual (07610-003-67-21) WASH MOTOR/DRAIN PLUMBING/WAREFORCE™ UL 30 WASH MANIFOLD ASSEMBLY Area within this box is an overview of the Avenger LT wash manifold assembly For the Avenger LT replace Item one below with this manifold See Motor & Pump Assembly Page Ball Valve Assembly AVENGER LT 115V &...
Page 40
WAREFORCE UH/UL 30 Technical Manual (07610-003-67-21) WASH MOTOR/DRAIN PLUMBING/WAREFORCE™ UL 30 WASH MANIFOLD ASSEMBLY Item QTY Description Part Number HUB, DISCHARGE MACHINED (WAREFORCE™ UH 30 SHOWN) 05700-021-37-90 LOWER, WASH MANIFOLD (WAREFORCE™ UL 30) 05700-021-52-80 GASKET, MANIFOLD 05330-200-23-00 NUT, JAM 1-1/2”-12 NPT 05700-000-86-23 HOSE CLAMP, 1-5/16”-2 1/4”...
Page 46
WAREFORCE UH/UL 30 Technical Manual (07610-003-67-21) WAREFORCE UH/UL 30 DOOR ASSEMBLY (CONTINUED) Item QTY Description Part Number OUTER DOOR WELDMENT 05700-003-33-37 INNER DOOR 05700-003-33-21 DOOR HANDLE 05700-003-26-62 BOLT, 1/4” -20 X 3/8” LONG 05305-274-20-00 CHANNEL, RIGHT SEAL 05700-003-33-19 CHANNEL, LEFT SEAL 05700-003-33-20 CHANNEL, TOP SEAL 05700-003-33-22...
WAREFORCE UH/UL 30 Technical Manual (07610-003-67-21) MISCELLANEOUS DOOR COMPONENTS Door Switch & Bracket Assembly 05700-003-32-21 Switch Mounting Plate Door Switch Assembly 05930-003-31-44 Door Switch Bracket 05700-003-33-54 05700-003-31-43 Hardware: Locknut, 6-32 S/S Hex with Nylon Insert 05310-373-03-00 Door Spring 05700-003-32-85 Screw, 6-32 X 1 /4" Flat Head 05305-171-01-00 Hinge Stop Assembly Right (Shown): 05700-003-32-61...
WAREFORCE UH/UL 30 Technical Manual (07610-003-67-21) STANDS & COMPONENTS INSTALLATION INSTRUCTIONS: To install the stand, first remove the adjustable feet from the machine. Place machine on table and use the square mounting holes to line up the machine. Re-insert the adjustable feet through bottom of table top and tighten to lock machine to table.
WAREFORCE UH/UL 30 Technical Manual (07610-003-67-21) HTS-11 (SCALE PREVENTION & CORROSION CONTROL DEVICE) Kleenware HTS-11 System Replacement Cartridge 04730-003-28-03 (Inspect at least every 6 months) 04730-003-28-04 Replacement Test Strip The HTS-11 Must be installed vertically. The provided 06401-003-28-06 bracket is to be secured to the wall. Observe proper inlet/outlet water directions.
WAREFORCE UH/UL 30 Technical Manual (07610-003-67-21) GO BOX KIT A GO Box is a kit of the most needed parts for a particular model or model family to successfully ef- fect a repair in the first call 90% or more of the time. Item QTY Description Part Number...