PROBLEM
Rinse water not at required temperature
range.
After filling machine with water, leakage
began at lower front panel without machine
operating or at end of rinse cycle.
Machine doesn't drain when
'off/drain' switch is depressed.
Note: The drain pump of this machine is part of wash motor, so if was motor operates properly drain system should work.
TROUBLE SHOOTING GUIDE
Thermostat defective.
Water level protection control defective.
Heater element defective.
R-2 defective.
Thermometer's defective.
Thermostat defective.
Defective heater relay on contactor.
Overflow drain clogged.
Drain solenoid clogged. Defective switch.
Defective motor or motor start relay.
Defective drain solenoid.
Defective timer.
Defective relay.
CAUSE
SOLUTION
Adjust using instructions on thermostat
page and heater system's checkout page.
Replace if necessary.
Replace. (Auto/fill would run continuously.)
Replace.
Replace.
Replace.
Adjust using instructions on thermostat
page and heater system's checkout page.
Replace if necessary.
If defective, replace. See note on heater
system above.
Clean away obstruction.
Remove obstruction. Replace.
Replace.
Replace.
Replace timer.
Replace.