Jackson 24A-AF Instruction Manual page 7

Installation of Top and Sides on 'F' and 'P' Models:
1. Insert rear barrier with angle facing out. Install prior to placing top on uit.
2. Place top on unit, making sure front lip is under flange, but does not interfere with latch or switch
mechanism. Place studs in holes on back of unit. Use 1/4-20 nuts.
NOTE: For 'P' models, omit steps 1 and 2.
3. Remove kickplate. Open door and place side panel lip at door opening. Work panel under top by
pushing with palm of hand. Put self-tapping screws in four places. Both side panels are installed in the
same way. Note: If unit being installed is an 'F' model, do not put the bottom rear self-tapping screw in
each panel until step 4.
4. 'F' models require a back panel. For installation, slide back panel behind lip of side panels and secure
with the two remaining self-tapping screws.