Measure Main Pressure - Skoda Octavia Workshop Manual

OCTAVIA
Edition 06.03
S00.5116.60.20
Shift Mechanism/Housing
- If the final speed is not reached, the follow-
ing faults may be present:
Speed too high
Speed too low
by up to 200 rpm:
Speed too low by
above 200 rpm:
In case of doubt always first check the engine
setting and if necessary correct.
The correct torque converter must always be
assigned to the correct gearbox ⇒ page 00-2.

Measure main pressure

The pressure test gives information concerning
interference in the hydraulic control. It should
only be undertaken when all other tests result in
no origin of damage.
- Interrogate fault memory and correct possi-
ble electrical fault before measuring the main
pressure.
- Interrogate fault memory ⇒ page 01-6.
K - Unscrew bolt -arrow- for the main pressure
hole, always replace bolt, 15 Nm.
- Connect pressure tester (e.g. V.A.G 1702)
and during engine running bleed by means
of knurled screw.
- Increase ATF temperature to 60 °C, there-
fore connect V.A.G 1552 and read measured
value block ⇒ page 01-16.
Forward clutch slips,
overrunning clutch slips
Check engine setting
Torque converter defec
tive.
------------ ------------
37