Disassembling And Assembling Reverse Gear Clutch -K2 - Skoda Octavia Workshop Manual

38

Disassembling and assembling reverse gear clutch -K2-

Special tools, testers and aids required
♦ Pressure plate MP 3-406
♦ Removal device MP 3-481/3
♦ Assembly ring MP 3-491
Note:
When carrying out repairs on the clutch, ensure
that the ball valve (arrow) is not damaged.
1 - Circlip
♦ After removing, mark and re-insert at
the same point
♦ Thickness differs
2 - Pressure plate
♦ Position serrated or smoothly ground
face end pointing toward internally-
toothed discs
♦ Thickness differs
♦ Is supplied as a replacement part as-
signed to gearbox code letters
3 - Externally-toothed disc
♦ Quantity ⇒ page 00-2
------------ 38-8 ------------
Gears/Hydraulic Control
4 - Internally-toothed disc
♦ Quantity ⇒ page 00-2
♦ Place new internally-toothed disc in
5 - Corrugated spring washer
6 - Circlip
♦ Removing and installing ⇒ Fig. 1
♦ Fitting location ⇒ Fig. 2
7 - Spring supporting disc
♦ With springs
♦ Fitting location ⇒ Fig. 2
♦ Preassemble with spring supporting
8 - Spring supporting ring
9 - Piston
♦ To remove from clutch bell, lift out with
♦ Sealing lips are vulcanized to piston
♦ Moisten sealing lips with ATF before
♦ Do not tilt piston when installing
10 - Clutch bell
ATF for 15 minutes before installing
ring for installing. Ensure springs are
correctly located
screwdriver at several points
inserting
OCTAVIA
Edition 01.98
S00.5116.52.20