1. Package Contents Thank you for purchasing PLANET Gigabit Multi-Homing VPN Security Router, SG- 4800, and this Quick Installation Guide will introduce how to finish the basic setting to connect the internet. Open the box of the VPN Security Router and carefully unpack it. The box should contain the following items: SG-4800 x 1 Quick Installation Guide x 1 User’s Manual CD x 1 Power Cord x 1 Cat5 Cable x 1 19 inches Brackets x 2 Bracket Screw x 8 If any of above items are damaged or missing, please contact your dealer...
2. Hardware Installation The followings are instructions for setting up PLANET SG-4800. Refer to the illustration and follow the simple steps below to quickly install your VPN Security Router. 2.1 Safety Instruction The following is the safety instructions for VPN Security Router before installing. The maximum operating temperature of the router is 50ºC. Care must be taken to allow sufficient air circulation.
2.3 LED & Button definition Color Status Description Green Steady Power On Power Off Steady On System is crashed. System is on self-test after power on the DIAG Amber Blinking device. System is ready. Steady On Port has been connected & gets IP. WAN/DMZ Blinking Transmit data. Green LINK/ACT Not get the IP address, even the port has been connected. Steady On LAN port has been connected. Green LINK/ACT Blinking Transmit data. Green Steady On Works on 1000Mbps. LAN/ WAN/DMZ Amber...
Step 2. Start a web browser. To use the user interface, you need a PC with Internet Explorer (version 6 and higher), Firefox, or Safari (for Mac). Step 3. Enter the default IP address of the router: 192.168.1.1 into the URL address box. Step 4. Enter the default user name admin and the default password admin. Then click Login to enter Web-based user interface. Figure 3-1 Login page of the SG-4800 Default LAN IP: 192.168.1.1 Default Name: admin Default Password: admin...
3.2 Configuring the WAN Step 1. Go to Network Network Connection to find WAN Setting. Figure 3-2 Network connection button Figure 3-3 Multi-WAN interface setting page...
Page 9
Step 2. Click Edit to enter WAN configuration page. Figure 3-4 WAN configuration page There are six types of WAN connection. They are Obtain an IP automatically, Static IP, PPPoE (Point-to-Point Protocol over Ethernet), PPTP (Point-to-Point Tunneling Protocol), Transparent Bridge or Router Plus NAT Mode. Users can choose according to their actual network structure. You can find detail setting process in the user manual.
3.3 Remote Management The function can enable users to manage the security router at remote sites and to allow technical person to assist you in solving network problem. Step 1. Go to Firewall General Policy. Figure 3-6 The firewall setting button Figure 3-7 General Policy setting page Step 2. Click Enable to active Remote Management. And then enter the control port you want to use. The default value is 8080. Step 3. Click Apply to save the configuration. And you can type the http://WAN IP address: 8080 to access the router from the remote side.
Page 11
Step 4. To verify the IP addresses of your computer and the security router. Click Start form Windows Run. Type the cmd to open the command window, then type ipconfig for getting default gateway address. In the below case, the default gateway is 192.168.1.1 and the user’s PC is 192.168.1.100.