Viewfinder Screen Status Displays - Panasonic AJ-HPX3700G Operating Instructions Manual

!"#$%&'())*#+,-.+/012345677899(/9:;<99=>>?@A>BACDEFGDEHIJKL?M

Viewfinder Screen Status Displays

In addition to video images, the viewfinder displays lamps and text that indicate the settings and operating status of the unit,
together with messages, a center marker, a safety zone marker and the camera ID.
Lamps in the Viewfinder Screen
2
The above viewfinder is the AJ-HVF21G (for further information
on your optional viewfinder model, see the relevant instruction
manual).
1. TALLY/REC (recording) Lamp
This lamp stays illuminated in red during recording, and
starts blinking if any abnormal action occurs.
For more information, see [Warning System]
(page 160).
Mode Check Screen Displays (MODE CHECK button function)
The viewfinder can display a screen that allows you to check
the settings and status of the unit.
Each press of the MODE CHECK button switches the
screen as follows:
STATUS screen ! !LED screen ! FUNCTION screen !
AUDIO screen ! CAC screen ! USER SW STATUS screen
! No indication
Each screen is displayed for about 5 seconds. A press of the
MODE CHECK button switches the current screen.
Whether or not to display each screen is specified through
the <MODE CHECK IND> screen, which is accessible from
the VF page.
76
Adjustments and Settings for Recording: Viewfinder Screen Status Displays
1
4
2. Abnormal Operating Status Warning Lamp
This lamp comes on when the unit is in any of the
abnormal operating statuses specified through the
<!LED> menu screen.
For statuses that activate the lamp, see the options in
the [!LED] (page 189).
3. BATT (battery) Lamp
This lamp starts blinking a few minutes before the
battery charge starts to run out, and stays illuminated
after the battery is completely flat. The battery should be
replaced before it is nearly flat, so that operation will not
be interrupted.
For more information, see [Warning System]
(page 160).
4. SAVE Lamp
In the normal setting:
The lamp stays on when the SAVE switch is positioned
at [ON] and the output of video and audio is power-
saved.
When the menu option SAVE LED is set to
"P2CARD":
The lamp starts blinking when the P2 card remaining
free space is getting low.
The menu option SAVE LED can be found in the <VF
INDICATOR3> screen on the VF page.