Viewfinder Screen Status Displays; Viewfinder Lamp Displays - Panasonic AJ-SDX900E Operating Instructions Manual

CONTENTS
Chapter 4 Adjustments and settings for recording
4-7 Viewfinder screen status
displays
Not only the images but the lamps and characters indicating
the unit's settings and operation statuses as well as the
messages, centre and safety zone markers, camera ID and
other information are displayed inside the viewfinder.
4-7-1

Viewfinder lamp displays

1 5
TALLY / REC
50
BATT
VTR
SAVE
2 3 4
1
TALLY/REC (recording) lamp
This lights up (red) during recording. It flashes when a
problem has occurred. For details, refer to the appropriate
section in "6-3 Warning system."
2
(abnormal operating status warning) lamp
This lights when the unit is set to an abnormal operating
status for any of the items set to "ON" on the "!LED" screen
of the setting menu.
For details on selecting the items which are to be indicated
with the lamp, refer to the
"Chapter 7 Menu description tables."
3
BATT (battery) lamp
This starts flashing when the battery voltage has dropped
to the level where the battery will no longer be usable in
several minutes' time, and it lights when the battery is no
longer usable. To prevent operation from being
interrupted, replace the battery before the battery has
discharged completely. For details, refer to the appropriate
section in "6-3 Warning system."
4 VTR SAVE (VTR power-saving) lamp
This lights when the VTR SAVE/STBY switch is set to
SAVE. It goes off during recording.
<Note>
In the rec pause mode, the SAVE mode is established
automatically, and the lamp lights after the time set for the
pause timer (temporary stop time) has elapsed.
After two minutes in the play pause mode, the SAVE mode
is established automatically, and the lamp lights.
5 50 (50 Mbps recording/playback) lamp
This lights when a tape is being played back at 50 Mbps
while the mode for recording or playback at 50 Mbps is
selected.
38
Viewfinder pictured here
is the AJ-VF20P. (For
details concerning
viewfinder, refer to the
operating instructions of
each viewfinder.)
<!LED> screen items in
4-7-2 Viewfinder screen status
display configuration
All the items that can be displayed are laid out inside the
viewfinder as shown in the figure below.
I H G J
1
50i 11 / 250 S DZ
2
:
E X 2 4. 0K
-- GAIN -- -- USER SW GAIN --
LOW : 0 S.GAIN:30/36/42/48
3
MID : 9
HIGH:18 DS.GAIN: 6 /12 /20
4
UM:S.GAIN 30 d B
5
U1:AUDIO 1 FRNT U2:DS.GAIN
:
REC WARNING
TCG 00:00:00:00
:
6 F:1---- ---+
∫
1A A 18 d B F:2---- ---+
∫
6
7 9 8 ;
For details, refer to the following pages.
4-7-3 Selecting
screen display items
To select which items are to be displayed on the viewfinder
screen, perform menu operations to open the <VF
INDICATOR1> screen or <VF INDICATOR2> screen from the
VF page, and select ON or OFF for the display or select the
type desired for each item concerned.
For details on operation, refer to
operations."
#< VF INDICATOR1 >
EXTENDER :ON
SHUTTER :ON
FILTER :ON
WHITE :ON
GAIN :ON
IRIS :S+IRIS
CAMERA ID :BAR
ID POSITION :UPPER L
DATE/TIME :OFF
ZOOM LVL :ON
COLOR TEMP :ON
CAMERA MODE :ON
#< VF INDICATOR2 >
TAPE :ON
BATTERY :ON
AUDIO LVL :ON
TC :OFF
VTR WARNING :NORMAL
SAVE LED :SAVE
F E D
C
10min REC14. 6V
∑
B
/34min DIGITAL14
:
: :
A
:
6
ID
@
iREC
23h59m
++F14 Z99 .
< = > ?
the viewfinder
"4-6-2 Basic menu