Panasonic AJ-HPX3700G Operating Instructions Manual page 93

!"#$%&'())*#+,-.+/012345677899Q'9:;<99=>>?@A>BACDEFGDEHIJKL?M
4
To format the SD memory card, turn the jog dial button
to move the arrow (cursor) to YES. Then, press the dial
button.
When the SD memory card has been formatted, the
following message appears:
The card will not be formatted if the following message
appears when the jog dial button is pressed:
Error message
CONFIG NG
NO CARD
(No SD memory card inserted.)
CONFIG NG
ERROR
(SD memory card cannot be
formatted.)
CONFIG NG
WRITE PROTECT
(SD memory card is write-
protected.)
CONFIG NG
CANNOT ACCESS
(SD memory card not
accessible).
5
To exit the menu, press the MENU button.
The settings menu disappears and the status of the unit
is indicated at the top and bottom of the viewfinder
screen.
#Note
When an SD memory card is inserted or removed with
the <SD CARD READ/WRITE> screen open, the titles
of data on the card cannot be updated.
Move the cursor to the option TITLE READ and press
the jog dial button. The titles of the data will be updated.
Remedy
Insert an SD memory card.
The card may be defective.
Replace the card.
Remove the card and cancel the
protect.
Example: The SD memory card
is not accessible because it is
being played back.
After the operation in process,
format the card.
To write set data on an SD memory card
1
Navigate the menu to the <SD CARD READ/WRITE>
screen.
To select a file number
2
Turn the jog dial button to move the arrow (cursor) to the
option W.SELECT. Then, press the dial button.
3
Turn the jog dial button to select a desired number (1 -
8). Then, press the dial button.
To give the selected file a title
4
Turn the jog dial button to move the arrow (cursor) to the
option TITLE.
5
Press the jog dial button. This moves the arrow (cursor)
to the entry area, putting the unit in entry mode.
Adjustments and Settings for Recording: Handling data
93