Table of Contents
Advertisement
Warning: The Product ID should ONLY be modified by qualified service
personnel. This value should always match the Product ID located on the
chassis.
Enter the product ID and press the Enter key.
7.
Press the F10 key to confirm exiting System Utilities. The server automatically reboots.
8.
HPE 550 W Power Supply
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
CAUTION: To prevent damage to electrical components, take the appropriate anti-static
precautions before beginning any installation, removal, or replacement procedure. Improper
grounding can cause electrostatic discharge.
To remove the component:
Power down the server (on page 27).
1.
Access the product rear panel (on page 30).
2.
Release the power cord from the strain relief clip.
3.
Remove all power:
4.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Remove the server from the rack (on page 30).
5.
Place the server on a sturdy, level surface.
6.
Remove the access panel
7.
Remove the air baffle
8.
If the primary PCI riser cage is installed, do the following:
9.
Remove the primary PCI riser cage
a.
("Access
panel" on page 35).
("Air
baffle" on page 36).
("Remove the PCI riser
cages" on page 31).
Removal and replacement procedures 76
Advertisement
Table of Contents
