Hp 550-W Power Supply (Non-Hot Plug) - HP ProLiant DL180 Gen9 Service Manual

Enter the serial number and press the Enter key.
6.
Select Product ID. The following warning appears:
7.
Warning: The Product ID should ONLY be modified by qualified service
personnel. This value should always match the Product ID located on the
chassis.
Enter the product ID and press the Enter key.
8.
Press the Esc key to close the menu.
9.
Press the Esc key to exit RBSU.
10.
Press the F10 key to confirm exiting RBSU. The server automatically reboots.
11.

HP 550-W Power Supply (non-hot plug)

WARNING:
internal system components to cool before touching them.
CAUTION:
precautions before beginning any installation, removal, or replacement procedure. Improper
grounding can cause electrostatic discharge.
To remove the component:
Power down the server (on page 26).
1.
Access the product rear panel (on page 28).
2.
Release the power cord from the strain relief clip.
3.
Remove all power:
4.
Disconnect the power cord from the power source.
a.
Disconnect the power cord from the server.
b.
Remove the server from the rack (on page 29).
5.
Remove the access panel
6.
If installed, remove the secondary PCI riser cage
7.
To reduce the risk of personal injury from hot surfaces, allow the drives and the
To prevent damage to electrical components, take the appropriate anti-static
("Access panel" on page 37).
("Remove the PCI riser cages" on page 29).
Removal and replacement procedures 80