Network Settings; Connection Via A Hub - Barco Galaxy NH-12 User Manual

R / PR R / PR
IN1 IN1
DESKTOP INPUT DESKTOP INPUT
HUB
Image 4-28

Connection via a hub

See Network settings to set the communication port.
The linking of projectors is treated in the section "Setup of the linked projectors in a multichannel system"

4.5.13.2 Network settings

C
AUTION
In normal conditions, the network detection takes few seconds. This means that the total time needed to go
from power ON to Standby mode is only a few seconds. This value can vary depending on the speed of the
network connection.
But when the DHCP setting of the projector is set to Yes and the network does not allow the projector to obtain
an IP address from the DHCP server, the startup time will be delayed by upto five minutes. After this time, a
time-out occurs if the network detection fails, and the projector starts up without any network connection.
What can be done?
These settings are used to set the Ethernet Communication parameters.
R59770122 BARCO GALAXY NH-12 20/01/2015
G / Y G / Y B / PB B / PB Hs / Cs Hs / Cs Vs Vs VIDEO VIDEO S-VIDEO S-VIDEO
DVI DVI COMPUTER COMPUTER
IN2 IN2 IN1 IN1 IN2 IN2 IN1 IN1 IN2 IN2
L1 L1 L2 L2 L3 L3
STEREO INPUT STEREO INPUT STEREO OUTPUT STEREO OUTPUT
RS 232 C RS 232 C DVI DVI R.C. R.C.
To LAN
:
Make sure that a DHCP server is available in the network and works fine.
4. Installation
33