Operation Options; Autoimage; Warning Messages - Barco Galaxy NH-12 User Manual

7.11.4 Operation options

Overview
•

AutoImage

•

Warning messages

7.11.4.1 AutoImage
What can be done ?
AutoImage can be disabled. In case of a new (unknow) source, no automatic file selection will be done. Instead, a more or less
suited file will be selected, resulting in a misaligned image. Image settings must be done manually (edit image file).
How to enable/disable AutoImage ?
1. Press MENU to activate the Tool bar
2. Press → to select the Service item
3. Press ↓ to Pull down the menu
4. Use ↑ or ↓ to select Operation options
5. Press → to pull down the menu
6. Press ↓ to select Autoimage
7. Press → to pull down the menu
8. Use ↑ or ↓ to select On/Off
9. Press ENTER
Image 7-236
A white bullet shows the active setting
7.11.4.2 Warning messages
What can be done?
It is possible to block some Warning messages during projector runtime. The table below gives an overview of those messages that
can be suppressed during runtime.
Warning message
NO SIGNAL
Lamp error icon
Lamp runtime warning
Lamp runtime exceeded
Desktop resolution not valid
Wait box
For safety reasons, the warning messages Lamp runtime warning and Lamp runtime exceeded will always
pop up during start-up of the projector. They can only be suppressed during projector runtime.
R59770122 BARCO GALAXY NH-12 20/01/2015
Sim 5W Galaxy NH-12
Galaxy NW-12
Galaxy NW-7
x
x
x
x
x
Description
x
In case no incoming Sync is detected
In case of an actual lamp or LPS problem
x
Max lamp runtime almost reached
x
Max lamp runtime exceeded
x
Desktop input signal resolution is out of
specification.
x
An hourglass icon that is displayed during
processing
7. Advanced
181