Moving The Desired White Point - Barco Galaxy NH-12 User Manual

7. Advanced
Fine tuning colors
If the color impression amongst different devices in a multiple channel display system is slightly different, you can manually fine
tune the desired X and Y value of the white point in the active Dynacolor set to match the colors. Always keep the CIE chromaticity
diagram in mind while changing the white point position:
• Increasing the desired X value of the white point makes the image look more reddish;
• Decreasing the desired X value of the white point makes the image look more cyanish;
• Increasing the desired Y value of the white point makes the image look more greenish;
• Decreasing the desired Y value of the white point makes the image look more magenta-ish;
• Etcetera.
y
0.8
G
0.6
0.4
0.2
B
0
0 0.2
Image 7-159

Moving the desired white point

C
AUTION
Fine tuning the color of the projected image
1. In the OSD, navigate to the active Dynacolor set: Display setup > Dynacolor > or Adjust Set 1...> Adjust Set 2... or Adjust Infitec
A... or Adjust Infitec B...
2. Press ENTER to confirm your selection.
142
W
0.4 0.6
:
Color fine tuning may only be done by Barco trained and qualified engineers.
R
x
0.8
R59770122 BARCO GALAXY NH-12 20/01/2015