Entering Data For Administrative Options - Avaya one-X 9601 Installation And Maintenance Manual

2. For non-touchscreen phones, use the navigation arrows to scroll to and highlight the local
procedure you want, then press Select or OK. Or scroll to the procedure you want and
press the corresponding line button. For touchscreen phones, scroll to the local procedure
you want if it not already displayed then touch the line on which the local procedure you
want appears.

Entering Data for Administrative Options

This section applies to all 9600 Series IP Deskphones and describes how to enter data for
administrative options.
1. With the exception of a touchscreen deskphone, the first application line on any screen is
automatically highlighted (selected) when the deskphone displays the screen. To select the
item on that line, press the appropriate softkey at the bottom of the screen, for example,
Change or Save, or the OK button. To select a different line, use the down or up navigation
arrows to change the line focus. When the desired line is highlighted, then press a softkey
or OK to select that line. For a touchscreen deskphone, touching the desired line produces
the same result.
2. Attempts to enter invalid data are rejected and the deskphone emits an error beep.
3. If you enter a numeric digit that causes the IP Address or subnet mask value to exceed 255,
or any value to exceed its maximum field value, an error beep tone sounds, the digit is
ignored, and the cursor does not move forward.
4. If you enter a numeric digit for a value or for an IP Address or subnet mask field after
entering only a zero, the new digit replaces the zero.
5. To backspace on non-touchscreen phones, press the leftmost softkey; for a touchscreen
deskphone, use the Bksp softkey instead. When you press the applicable button or key to
backspace, the most recently entered digit or period is erased from the display. The cursor
remains in the erased character's former position.
6. The More softkey provides data entry options like symbols, all capital letters for text,
numerals, etc.
7. Pressing Back or Exit (or touching that softkey for a touchscreen deskphone) exits the local
procedures. If any changes were made using the ADDR procedure, 802.1X data, or if the
Crafts Entry screen was invoked during startup, the deskphone immediately resets.
Otherwise, the telephone re-displays whatever had been displayed when the Craft Local
Procedures were invoked.. If no ADDR changes were made or if the local procedures were
invoked post-startup, the deskphone redisplays the screen (or other display) that was
effective when the craft option was invoked.
Note:
If PROCSTAT has been administered to 1, you will not be able to invoke any
Note:
administrative options other than V I E W.
Entering Data for Administrative Options
Issue 1 December 2010 29