Static Administration; Static Administration Options; Entering Data For Administrative Options - Avaya 4600 Series Installation Manual

Static Administration

Static Administration Options

A number of settings can be altered through the telephone after installation. Note however that values
assigned through static administration will not be changed by future upgrade scripts. They will remain
active for the IP Telephone until a new boot file is downloaded.
These procedures should only be used if you are using static address installation. Do not use these
procedures if you are using DHCP.
• To set parameters for all Avaya H.323 IP phones on a system, you can edit the 46XXsettings.scr
script file. See The 46XX Settings Script File.

Entering Data for Administrative Options

This section describes how to enter data for the administrative options.
1. All local procedures are started by dialing Hold and then a sequence of up to 7 numbers followed
by #.
2. A 6-second timeout is in effect between button presses after the Hold button is pressed; if a valid
button is not pressed within 6 seconds of the previous button, the collected digits are discarded,
and no administrative option is started.
3. Attempts to enter invalid data are rejected, and the phone emits an error beep.
4. If a numeric digit is entered for a value or for a field of an IP address or subnet mask after only a
zero has been entered, the new digit will replace the zero.
5. Press # to go to the next step.
6. To backspace within a field depends upon the phone type:
•
4601, 4602, 5601, 5602:
•
4606:
• 4612 & 4624:
• 4610, 4620, 5610, 5620: Left-most key.
IP Phone Installation
IP Office 3.1
Speaker key.
Conference key.
Previous key.
Issue 11c (14th September 2005)
Page 29