Removing The Interface Cable; Connecting To A Host - Symbol LS1900 Series Product Reference Manual

LS1900 Series Product Reference Guide

Removing the Interface Cable

Different cables are required for different hosts. To remove the interface cable:
1. Unplug the installed cable's modular connector by depressing the connector clip
with the tip of a screwdriver.
2. Carefully slide out the cable.
3. Follow the steps for Installing the Interface Cable on page 1-3 to connect a new
cable.

Connecting to a Host

The LS1900 Series scanner supports RS-232C, Keyboard Wedge, Wand Emulation, and
Synapse to interface to a host system. This section describes how to set up each of these
connections.
Connecting Power
If your host does not provide power to the scanner, you will need an external power
connection to the scanner:
1. Connect the interface cable to the bottom of the scanner, as described in Installing
the Interface Cable on page 1-3.
2. Connect the other end of the interface cable to the host (refer to your host manual
to locate the correct port).
3. Plug the power supply into the power jack on the interface cable. Plug the other
end of the power supply into an AC outlet.
1-4