Connecting A Synapse Cable Interface; Removing The Interface Cable - Symbol LS 4008i Product Reference Manual

Connecting a Synapse Cable Interface

Note: See the Synapse Interface Guide provided with your Synapse cable
for detailed setup instructions.
Symbol's Synapse Smart Cables enable interfacing to a variety of hosts. The appropriate
Synapse cable has the built-in intelligence to detect the host to which it is connected.
To host
Synapse Smart Cable
1. Plug the Synapse adapter cable (p/n
as described in
2. Align the 'S' on the Synapse adapter cable with the 'S' on the Synapse Smart Cable
and plug the cable in.
3. Connect the other end of the Synapse Smart Cable to the host.

Removing the Interface Cable

To remove the interface cable:
1. Unplug the installed cable's modular connector by depressing the connector clip
with the tip of a screwdriver.
2. Carefully slide out the cable.
3. Follow the steps for
cable.
Figure 1-3. Synapse Cable Connection
Installing the Interface Cable
Installing the Interface Cable
into the bottom of the scanner,
25-32463-xx)
on page 1-3.
on page 1-3 to connect a new
Getting Started
Synapse adapter cable
To scanner
1-5